Display Config-Manual

Function Introduction: Move the display area so that the arc position is in the center.

Setting Step(Move the display area）：

(1 )Enter "System Debug" Menu.

(2) Select the" Display Config-Manual " and press " Menu " to enter the page.

(3 )The screen will show “Place Fiber, Press ’Enter‘”.

(4) After inserting the fiber optic cable, press “Menu” to continue.

(5) Press “Up and down ”and “Left and right ”to manually adjust the position of the optical fiber on the x screen.

(6) Press “X/Y” to switch to the Y screen

(7) Press “Up and down ” and “Left and right ”to manually adjust the position of the optical fiber on the Y screen.

(8) Done