Fiber Displacement Adjust

Resolve exception that fiber displaced from center of screen

0. Unusual Phenomena

0.1. Fiber displaced from center and warning "Replace Fiber".

0.2. Fiber displaced from center and moving up and down persistently.

0.3. Fibers collide while moving forward.

0.4. Two V grooves are not in line.

1. Clean V Groove

1.1. Clean left V groove with art knife.

1.2. Clean right V groove with art knife.

2. Select Mode

2.1. Press “Menu" and enter "Parameter Set".

2.2. Select option "Operation Mode".

2.3. Press "Menu" and switch to "Manual" mode.

2.4. Press "Exit" and return to fusion menu Manual (Figure 2.3).

3. Adjust Left V Groove

3.1. Place fiber into left V groove and close windproof cover. Fiber end must exceed electrodes. If Y fiber is not in the center of screen, repeat step 1.1. Clean left V groove.

3.2. Check right-side menu on screen. Press "Fusion button" to select second row, then press "Menu button" twice to switch to "x motor".

3.3. Hold "Up " or "Down" button until left fiber of X moves to center of x screen. Note: Fiber will move slowly, please be patient and keep pressing. You can hear buzzing while holding the button.

3.4. Place fiber into left V groove again. Fiber end must extend beyond the electrodes. Check whether left fiber of X is in the center of X screen. If fiber is not in the center, repeat step 3.3.

4. Adjust Right V Groove

4.1. Place fiber into right V groove and close windproof cover. Fiber end must extend beyond the electrodes. If X screen fiber is not in the center, repeat step 1.2. Clean the right V groove.

4.2. Check right-side menu second row. Press "Menu button" to switch to "y motor".

4.3. Hold "Up button" or "Down button" until right fiber of Y moves to center of y screen. Note: Fiber will move slowly, please be patient and keep pressing. You can hear buzzing while holding the button.

4.4. Place fiber into right V groove again. Fiber end must stand out beyond the electrodes. Check whether right fiber of Y is in the center of Y screen. If fiber is not in the center of screen, repeat step 4.3.

5. End