Arc-Power Test

Introduction: Doing arc testing once a month, can ensure that the fusion splicer will have the best performance.

Step:

1. Go to the menu

1.1. Go to the “Common function” menu.

1.2. Select “Arc test ”, press the“ menu ”to enter the page.

1.3. Press “Menu” again to enter the arc test menu. The screen will show “Place Fiber”, Press Enter.

2.Arc Test

2.1. Cut the fibers then put two of fibers in the fusion splicer, close the windproof cover and press “Menu”. The fusion splicer will be pushed-out, alignment and arc automatically adjusted.

2.2. After arc test, the left side of the screen will prompt with arc power and test results.

If prompted “Arc Power Too Weak/Too Strong”, open the windproof cover, repeat step 2.

2.3. If prompted “Arc Power OK”, press ”menu ” to save.

3. Done